Page 1 of 2
uic error
Posted:
Wed May 23, 2012 2:37 pm
by GaryVass
Not sure what it means but I keep getting a uic program caused an error when I try to compile my programs. This is with the latest windows version of q 7 basic.
Re: uic error
Posted:
Wed May 23, 2012 2:53 pm
by Henning
Make sure you don't have a Global.ui.
That has happened a few times, and I've never created it on purpose.
/Henning
Re: uic error
Posted:
Wed May 23, 2012 5:18 pm
by GaryVass
No. no global.ui.....
Re: uic error
Posted:
Wed May 23, 2012 6:16 pm
by Henning
Re: uic error
Posted:
Thu May 24, 2012 6:45 am
by berndnoetscher
Did you try a "clean & rebuild"?
Re: uic error
Posted:
Thu May 24, 2012 3:59 pm
by GaryVass
It was not the same error, at least as best I can tell
And yes, I did try the clean & rebuild first.
Re: uic error
Posted:
Fri May 25, 2012 7:00 am
by berndnoetscher
GaryVass wrote:It was not the same error, at least as best I can tell
And yes, I did try the clean & rebuild first.
Sorry. Do not know what the cause is. Does it work on Windows?
Can you send me the source code?
Re: uic error
Posted:
Fri May 25, 2012 7:36 am
by Slowdown
perhaps removing Q7Bruntime.obj
Re: uic error
Posted:
Tue May 29, 2012 10:26 am
by GaryVass
Removing the obj file did not change things... and it is he windows version. I have not tried the newest linux version yet... I may try that later today to see if it compiles there.
Re: uic error
Posted:
Tue May 29, 2012 12:53 pm
by Henning
What is the complete error message?
/Henning