Q7B IDE - can't set focus to a Sub in module

[blatman]

Basic for QT 4.8.0 - Win XP SP3 on VirtualBox 4.1.18 on OSX 10.6.8
Whilst working on a module page in the IDE I found I couldn't always jump the focus to a Sub in the Sub button list.
There appears to be a limitation on the length of page.

eg:
Module IDE Sub button shows Subs (3)

Line 1 Sub1()
' these lines can be empty
Line 2145 End Sub

Line 2147 Sub2() ' positioned at line 2147 there will be a Sub separating line displayed
' these lines can be empty
Line 2160 End Sub

Line 2165 Sub3() ' cannot gain focus by using IDE Sub button

Line 2180 End Sub

If Sub2() is chosen from the Sub button list in the IDE Sub2() will gain focus in the page but if the Sub2() is moved to line 2148 the separating line will disappear and Sub2() and all successive Subs will not be able to take focus using the IDE Sub button list

Cheers.

[Slowdown]

confirmed.
But a sub of 2144 lines is not a sub but a complete program
Limit here is 2140 lines.

[blatman]

Hi Slowdown,

yes, the example is rather big for a Sub - I reduced the number of Subs in the Module page to ensure that was not an issue but the original Module where I encountered the problem had about 46 smaller Subs in it and I hit the problem at about Sub32() which happened to be just after Line 2147.

Cheers.

[berndnoetscher]

Thanks I will take a look into it the next days...